Cutting wood with chainsaw

Procedure: There are by and large two bearings to cut, upwards and downwards. Most wood is cut best by setting the saw over the wood and chopping down through it (above left). Gravity will ordinarily pull the remove piece from the log and you can keep cutting in this style. However at times when the log or limb is under strain, chopping starting from the top will result in the wood to squeeze bringing about the saw to wind up stuck inside the cut. For this situation, it is best to cut upwards (above right) by putting the saw underneath the wood and slicing up through it. Utilizing the plastic wedge can help keep bigger logs from squeezing the saw chain. Cut extensions off tree first Branches First: With most fallen trees, it is best to start cutting at the extension end first. Begin by cutting off all limbs that are too little for kindling. Place the saw at the base of these limbs and cut them off smooth at the piece of the appendage or log where they are connected. Equalization: Search for extensions that may be holding the storage compartment over the ground. These extensions go about as props and can be useful in keeping the storage compartment lifted for simple cutting. You ought to watch the complete structure of the tree and arrangement your cutting in a sensible request, evacuating most props last. Trunks: As you advance from the highest point of the tree towards the storage compartment, the breadth of the wood will steadily thicken. You will in any case be cutting upwards or downwards, just it will be important to work the saw at distinctive points. Cut the wood with chainsaws at two 45 degree edges, or as an A-surrounded house. At the point when both sides of the logs are equitably cut, you ought to complete the piece by cutting straightforwardly descending or upward.