Sorts of cut

With a miter saw, you will have the capacity to make the accompanying cuts:

Straight Cross Cut

90o points, miter table set at the 0o position

For moldings on entryway or window outlines or straightforwardly on the divider (perfect for decking and encircling sheets).

Miter Cross Cut

Cutting edge set at an edge other than 90o, left or right miter, and miter table set at some point other than 0o

For entryway and window casing corners (45o)

To close baseboard corners (45o)

For making joints (30o or 45o), little pieces to close finishes, inside and outside baseboard corners, seat rail corners (45o)

Angle cut

The sharp edge is permitted to tilt: single incline, the cutting edge will tilt to one side; double angle, to one side or right

Calculated cuts under 90o (single slant) and more prominent than 90o (double slant)

For making joints (30o or 45o) , inside and outside corners for baseboards, seat rails (45o)

Compound cut (miter and incline)

A miter point and a slope edge in the meantime: both length and width are cut at edges other than 90°

For beautiful cornice embellishment, seat rails, rail and stile joints