Make an even undercut
that meets the top cut. Once more, if the tree is too thick, make the even
undercut from both sides of the tree, adjusting the two cuts with the goal that
you can make one straight undercut. You ought to now have an indent cut out of
the side of the tree confronting the felling bearing.
Verify there are no
individuals or creatures inside of the wellbeing range of the tree felling
zone. This is no less than 2 times the length of the tree you are felling.
Make a dive cut by
embeddings the lower piece of the cutting tool bar nose into the tree trunk
behind where you need the pivot to be. Dodge kick back. Try not to permit the
upper piece of the cutting tool bar nose to come into contact with the tree.
When you have embedded the tip of the Chainsaws
into the tree trunk, turn the cutting tool until it is parallel with the
directional score.
No comments:
Post a Comment